🔎 Optimized Search: SeaSense Stainless Steel Cup Holder - Recessed with Pad, Gasket, and Barb Review

Excellent quality, one of the best upgrades I have made to a boat, replacing the UV damaging plastic coasters with these.

Does what it does. Very good value for money. A 3 5/8 hole saw emerged, I used silicone caulk to glue. Only room for two with no structural issues so I switched to support legs for the rest (which are really excellent).

Very nice and high quality drink holder. Perfect fit for my 2002 Cobalt 246 (10 holders). Use some tape to create a side part for a snug fit instead of using the lip liner that came with the kit. I prefer the option to remove the holder if I want. Highly recommended. I added before and after photos.

This is a great cup holder. It fell right into the hole where the originals were. The originals were plastic and began to fall apart in the sun. I expect this will be the last keeper I need to buy for this boat. If the drain connector was the same size as the original connector I would give it five starts. Good buy, a bit pricey but worth it.

I have replaced all 6 white plastic coasters in my Glastron with these stainless steel coasters. I really like her. (We'll see how they hold up in the boat after a season or two.) They look great when installed and I've had no trouble fitting them into the existing holes in my boat. I plan to plug the hole in the ground or maybe put an LED in it. I would recommend them to anyone looking for a stylish drink holder for their boat.

Everything is fine but I had to do 2 things. I had to wrap tape around the base of each of them so they fit snugly in all 11 of my holes so they don't dangle or rumble. This is probably a boat issue, not a product issue. I then pulled the rubber fittings out of the bottom and coated them with silicone. I didn't want the water in the cup holders to drip into my carpeted compartments. They really spice up my deck boat and look great!

I installed the bowl on my boat late June 2016. Rust appeared on the bottom of the cup within 3 weeks. While the mug is stainless steel (and won't rust), the clip that holds the stylus in place isn't stainless steel (it looks like it's made of poor chrome steel). The clip is rusty. I went to the local marine store, bought a stainless steel E and replaced the rusty clip. I deducted 1 star because it was so cheap