Header banner
Revain logoHome Page
๐Ÿšด enhance your cycling experience with shimano sti lever hoods black, ultegra st-6800, pair logo

๐Ÿšด Enhance Your Cycling Experience with SHIMANO STI Lever Hoods Black, Ultegra ST-6800, Pair Review

5

ยท

Very good

Revainrating 5 out of 5ย ย 
Ratingย 
4.8
๐Ÿšดโ€โ™€๏ธ Cycling, ๐Ÿฅ‹ Sports & Fitness

View on AmazonView on ะฏM

Media

(2)
img 1 attached to ๐Ÿšด Enhance Your Cycling Experience with SHIMANO STI Lever Hoods Black, Ultegra ST-6800, Pair
img 2 attached to ๐Ÿšด Enhance Your Cycling Experience with SHIMANO STI Lever Hoods Black, Ultegra ST-6800, Pair

Description of ๐Ÿšด Enhance Your Cycling Experience with SHIMANO STI Lever Hoods Black, Ultegra ST-6800, Pair

Recommended Use: cyclocross, gravel, road cycling.

Reviews

Global ratings 5
  • 5
    4
  • 4
    1
  • 3
    0
  • 2
    0
  • 1
    0

Type of review

Revainrating 4 out of 5

Replacement for stock hood

When you need it, you need it. Same as lever Ultegra 6800. Easy to install. I'm not sure if they still make them. So if you need them, get them while you can. Should also work with same generation levers of 105, Tiagra etc.

Pros
  • Nice to use
Cons
  • Expensive

Revainrating 5 out of 5

Ultegra also fits 105

I have a Shimano 105 11 speed shifter (ST-5800) and haven't considered it as an option. It turns out that the hood for Ultegra (ST-6800) is also suitable for the 105. The box says it right. See the image I've attached. The pullers work great. I don't know why people needed soap or hand sanitizer. I can install without these things. I just tugged a little on one side and then a little on the other side until it snapped into place.

Pros
  • Best in Niche
Cons
  • Vulgarity

Revainrating 5 out of 5

Apply hand sanitizer.

These are genuine Shimano hoods as described. The application process was quite easy. As a tip to make it easier to put on without stretching, I would suggest pouring some hand sanitizer down the grips before pulling them over the levers. This allows the gum to slide over the handles more easily, as well as evaporate after completion. After about a day they contract a little. As with most pairs I've tried, there's always some room left on the sides of the hoods once installed, but nothingโ€ฆ

Pros
  • Excellent overall performance
Cons
  • Compatibility

Revainrating 5 out of 5

Great replacement OEM

These genuine Shimano brake lever covers (sleeves) were purchased to replace the original covers on my bike which was around 4 years old. These rubber cases are exposed to a lot of sunlight, sweat, accidental oil and grease, and things like sunscreen. After a while, the rubber on my original set began to stretch and loosen, causing them to slip. I bought these replacement parts and they fit like new and tight without slipping. These are genuine Shimano parts and are essential to the proper fitโ€ฆ

Pros
  • Very impressive
Cons
  • Fits

Revainrating 5 out of 5

Great fit, great update

They fit my Ultegra 6800 levers perfectly. It took a bit of fiddling to install them. They're nice and snug compared to my old hoods which were messy and curled up at the most inopportune moments, like putting the hoods on while climbing or running. My original hubcaps lasted about two years before falling off. (I drive about 4500 miles a year.) Hope they last. As far as I can tell these are legitimate Shimano parts; I couldn't find anything that led me to believe they were fake. (I onlyโ€ฆ

Pros
  • Dope ๐Ÿ”ฅ
Cons
  • Zero