Header banner
Revain logoHome Page
๐Ÿ”” sierra international u-joint bellows 18-2751 logo

๐Ÿ”” Sierra International U-Joint Bellows 18-2751 Review

3

ยท

Average

Revainrating 3.5 out of 5ย ย 
Ratingย 
3.5
๐Ÿš— Steering System, ๐ŸŽ๏ธ Performance Car Parts & Accessories

View on AmazonView on ะฏM

Media

(4)
img 1 attached to ๐Ÿ”” Sierra International U-Joint Bellows 18-2751
img 2 attached to ๐Ÿ”” Sierra International U-Joint Bellows 18-2751
img 3 attached to ๐Ÿ”” Sierra International U-Joint Bellows 18-2751
img 4 attached to ๐Ÿ”” Sierra International U-Joint Bellows 18-2751

Description of ๐Ÿ”” Sierra International U-Joint Bellows 18-2751

Fits : MC-I, R, MR, Alpha One & TR/TRS drives (1972-1990). Includes clamp. Visit Amazonโ€™s SONAR parts finder at fit-guideseastarsolutionscom to ensure this product will fit your application. 0. 0.

Reviews

Global ratings 3
  • 5
    2
  • 4
    0
  • 3
    0
  • 2
    0
  • 1
    1

Type of review

Revainrating 1 out of 5

Total Rip-Off! for my opinion

Based on my observations, this product failed to deliver any noticeable improvement to my car's steering. The only pro I can think of is that it was easy to install. However, the cons are numerous: it didn't fit properly, it was made of poor quality material, and it didn't last more than a few weeks. I would not recommend this product to anyone.

Pros
  • Keeps water and debris out, protecting the U-joint from damage and extending its lifespan.
Cons
  • Requires additional installation time and effort to attach to the U-joint.

Revainrating 5 out of 5

Perfect fit for my Alpha 1 Gen 1!

Good quality! I have an Alpha 1 Gen 1 outdrive and it fits perfectly - excellent quality tires. Don't buy cheap bellows that will force you to remove the actuator again. The clips were of excellent quality - they fit perfectly. Delivery in a box. Highly recommended.

Pros
  • Steering system
Cons
  • Something to add

Revainrating 5 out of 5

The part is the correct part of the Mercrusier bellows OEM

The bellows is the same correct part of the Mercrusier bellows. I replaced it with an OEM part in 1986. So last week I had a very small wear hole that is wearing out in the pin pivot area on the port side. Clamps, rubber, clamps right. I used Permatex Tack Sealer. I had to remove the old sealant and used the stripping paste very carefully. then I clean the contact point with the metal with a paint thinner. ALPHA 1 MR. MADE IN TAIWAN. DO NOT USE EL CHEAPO SILIONS. $55.18-2751

Pros
  • Rack and pinion
Cons
  • Wrinkled packaging