🔌 Slide-Co 243423 Peg: Clear, Pack of 6 - Self-Locking Shelf Support Bracket, 1/4" Thickness, Easy Installation with 1/4" Diameter Hole & 3/4" Wooden Shelf Compatibility Review

I had to replace some broken shelf supports because the contractor installed them upside down. They were exactly the same props except for the same product number printed on the plastic. Since the broken ones lasted ten years despite being installed incorrectly, I assume the new ones will outlive me. Very easy to install and the shelves slide straight into place with no problem. Sometimes everything just works.

We had a couple of cabinets that were about 15 years old and needed to be removed. Several of the old pegs broke or had already broken. When I was preparing to sell the house, I only needed it for work and didn't want to spend a fortune. These were the cheapest versions I could find and they worked great. They were a little tight, but I pushed them in with a little effort. Overall it helped me achieve my goal and it worked great.

Good product. Fits perfectly on our kitchen cabinets with 3/4" wide shelves and 0.25" (1/4") pin diameter. If you are unsure of the pin diameter, print out a measurement page from any hardware store website. Don't look at it I don't know what others have received but my package was sealed and they were all the same size I will be ordering more to keep as a backup as these are old ones being replaced, out plastic and will eventually break from the weight.

I was afraid that something unique and hard to replace would be in my house again. When one of my original pins broke I went to my local hardware store to find a replacement and as usual they didn't have anything quite like it which I replaced. I turned back to the reliable Revain.com and indeed found them. There were different sizes available so I had to be careful when ordering, but I got the right size and they fit perfectly. I now have a few spares in case more brackets break or I decide to

Considering they are grossly overpriced for pennies of molded plastic, one would hope they are fair. They work. Unfortunately, quality control seems to be overdue, and all the supports in the box have a sheath (foreign plastic) that prevents the mount from being pushed in (see photo). In other words, you can't slide your shelf past the clip onto the support seat where it should be. Working carefully with a paring knife, you can cut off the skin, but this is ridiculous. Modify each prop before…

I want to replace the broken ones in my kitchen cupboard. The ones I wanted were either 1/4" in diameter, but the ones I got were a little under 1/4" even though they said they were 1/4". about 1/4 inch but thought I'd take a picture and show you the difference if you're thinking of ordering this product. If you think mine is over a quarter inch long I'd like to know because I measured the outside, not the inside. When I put the smaller ones in my closet, they fell out entirely. So now I have…

I was delighted to receive them today until I tried to put my shelf on the one that replaced the original shelf support. It turns out they were made slightly shorter so that one corner of the shelf was a different height than the other three original corners, and the pin was slightly wider than the original 5mm pin holes, even though the new shelf supports are 5mm should amount. I had to twist and turn to insert new ones into the holes. And I said new because I had to replace all four corners…

I ordered these 6 packs hoping to only use 2 to replace my current cleats. The shelf support is slightly offset from the pin on my old clips - see picture. You need to replace all the supports, not just one, to level the shelf. As a result I got 5 pins, four corners and one central bar. The pen was also significantly larger than my old ones. My first impulse was to drill big holes in my cabinets, but as this is a permanent change I took my dremel and sanding wheel and after about 15 minutes…