🔧 Enhance Precision and Stability with Specialty Products Company 81260 Alignment Kit Review

Bought these for my 2015 Honda Civic for front use but once fitted they make no appreciable difference in camber in combination with AirLift struts. Not sure if I need a large diameter set or if my setup is unique, they are well made and delivered on time.

Required if you lower your vehicle with coilovers. This thing saved my fender and wheels. I had too much negative camber and it would have ripped my whole wheel off if I didn't know. 1st photo without fenders - without them and the photo with fenders - with them.

I used both the top and bottom strut holes to get enough overall camber. Managed to get the collapse of money from 1st time. SPC customer service is not very helpful in locating what you need if it is not in the catalog. I can read the catalog but sometimes you don't know what to look for and they don't help. Would buy more products from them if I could find them.

I finally got around to installing it on my daughter's 2009 Hyundai Elantra. Installation is quick, but make sure you have a set of large, deep metric sockets (I used 10, 16-19mm sockets) and a torque wrench. Instructions are clear and easy to follow and it really only took 10-15 minutes per bike - multiple breaks. With the fall sensor I was able to bring the fall back to tolerance.

I spend days at the track in my 2019 Hyundai Elantra GT Nline. Too much understeer at first. Front camber specification is +/- 0.0 degrees. The rear suspension has built-in negative camber. You can use these screws to adjust the camber of the front shock absorbers. I don't have camber gauges so it cost me $100 to install the bolts. The maximum camber that can be achieved with a single bolt is 1.4 degrees. Two bolts make more possible. - 1.4 - a big improvement, now it turns perfectly and is…

I always use SPC products when I can. Substitute! If you want 16mm use SPC 81280. Unfortunately my Honda Civic has no other way to adjust the camber without camber plates so I had to use these bolts. They replace a bolt or two that holds the shock absorber to your car. simple so you can fine tune camber, but if you want to make it easier buy camber plates.

I have a 2005 mb c320 base model. They are designed for easy installation for c230, amg or awd. This works for the c320 base but with a slight modification. After your wheels are off. Remove the strut bolt and replace it with the adjustable bolt you just purchased. Next, loosen the two screws that attach the rack to the spindle. After that it gets tricky, but it works. Adjust the camshaft bolt to correct camber. You've loosened the bottom two bolts even more as you continue to adjust the…