🔧 Sleek Performance: SpeTool 2 Flute Square Carbide Machine - Unleashing Precision and Efficiency Review

I was hoping to find a cheaper 1/8 2fl carbide end mill than the one I now use for cutting 1/8" and 3/16" brass. Unfortunately this is not the case. I couldn't find the speed and feed (including very slow for the test) that worked for this cutter. These end mills break in the flute, which is unusual. I don't want to give them a star because I'm pretty sure they're good for plastic, wood, maybe aluminum.

I was obsessed with these little details - my head would crack just to look at it funny. I decided to try the ones with a much shorter crop length but thought they would be less flexible. They worked great - I was able to cut through a 1/32" piece of brass on my CNC machine. Left clean cuts and I used 1 bit where I used to have to use half a dozen due to breakage in the process.

I like these bits. I just did a series of celtic knot engravings on cherry wood using these attachments with my Origin Shaper. I increased the speed to 30,000 rpm. This piece cut through the cherry like it was never there. The racquet was not damaged and heating was minimal. As always, the depth of cut per pass must be limited by the drill diameter. Therefore, remember that this drill bit cannot cut deeper than 1/16 inch in one pass. Multiple passes are also required to achieve any appreciable…