🔩 M3 Hex Brass Standoff Studs PCB Motherboard Spacer Bolt & Nut Assortment Kit - 120Pcs Review

This is the Cadillac spacer. Professionally made, great size, well packaged. They are far superior to plastic models. Plastic is good only when there might be a conductivity problem.

They fit perfectly in my homemade RC car. I plan to use them for PCB assembly, but I'm also into steampunk to use in hand projects. Came in an organized box with dividers much appreciated instead of pockets! No problems with threads on risers, bolts or nuts. Will buy again in the future!

Good range. The build quality/finish is good and it is particularly helpful that they come in a small plastic box with dividers. I needed a 3mm gauge to mount a relay board on a lawn sprinkler control panel. The 2.5mm standoffs used for the Raspberry Pi seem a bit small for a heavier relay board so I decided to use those instead. Very satisfied. Many Thanks.

Small vertical dividers between compartments not fixed. When I received my kit, one of the dividers was at the bottom of the box, covered by two different sized racks. I removed and separated the mixed parts. I put the baffle back in place and then used a soldering gun to fuse all the intersections on the top faces. A simple light tap on each end of the wall solved the problem. I rated this product 4 stars due to the above issue. Ray West, Mesa, Arizona