🔒 Raised Truck Bed Retractable Tie Down Anchors for Ford F150, Ford Super Duty, Chevrolet Silverado, GMC Sierra, Dodge RAM Review

Get rid of the hassles of your trailers and hitches not getting stuck. These items are very easy to install and will save you time securing your load on the bed of your truck. I ended up ordering a few more for friends and family.

There are more expensive options but I decided to stick with this model. I'm really glad I did this as it saved me some money, they were very easy to install, they look amazing and are very durable. I highly recommend them

Barely covers the holes on the top rail. The plastic lip under the lid's lip had to be modified to sit flush. Then finally plug them in and try to tighten them but they still wiggle at the tightest tension. However, they will not pop out. Saved a few bucks but doesn't fit my 2013 GMC Sierra 2500 at all.

Very easy to install. This will be good as now I don't have to use the factory settings which are at the foot of the bed and hard to reach. Now this little person will have it on an easy road when using tightdowns. The only downside is that they are a bit narrow for my Ford F150, but I was able to flatten them out so they don't really show much.

This product should fit in my truck. As you can see, it's not. The material and overall assembly of the ties are good. It's just annoying that it fits in a full-size Chevy and doesn't even cover the holes in the bed. I think Tacos and Nissan are best but not Chevrolet. The blocking part could not reach both ends of the bed. I could change them but why.

Installing them couldn't be simpler unless you can just throw them to bed and they install themselves. They didn't come with instructions so make sure You lower the outside edge first, or you will think they sent you the wrong size. If you use them over a polyethylene cap, don't over tighten them or they will buckle towards the center. I don't see any major differences from the $49 BullRing #4001 version I have on my F150 other than the Bull Ring logo molded into the top plate.

We ended up buying these for our Ford Ranger with a tough bed liner. The liner covered the original attachment points. Finally, since the original mounting points were on the inner side panels and the new ones were on the side rails, we used a jigsaw to cut out approximately 2 x 3 inch mounting points on the apron and the truck itself. The fact that they are retractable makes them even better. Consider buying another set to add four more attachment points in the middle of the rails for small…

They arrived yesterday. So I haven't had a chance to properly test them yet. But they feel solid. Pretty easy to install. You need to completely remove the screws, so I gave this task to the kid. First time using a screwdriver, no problems with it. It remains only to keep up with the lock washers included in the kit. To install them, remove the screws, hold the top plastic and drop the metal. Then tip it into the hole. Pull up and hold the latch to lock it and insert the screws. Make sure it is