Enhanced Stinger SPD511 PRO Series Power/Ground Distribution T-Block: Triple 4 Gauge Inputs for Optimal Performance Review

I have used this to run two Pioneer amps with KnuKoncept's 4 gauge oxygen free copper wire. Looks cheap/plasticky but works perfectly. It would be nice if the transparent cover screwed instead of snapped in for a more secure hold. However, the price is right and it works without problems.

This distribution is simple and reliable. The connections are tightened with a hex wrench, which is much better than a Phillips screwdriver. The only reason I didn't give 5 stars is that the plastic cover breaks off easily on impact. Maybe I'll solve this problem with some good old duct tape.

I have ordered 4 of these. 2 I'm using now, 2 are for a future update. They (positive and negative) are between my main power distribution center and split to go upstream to the appropriate amplifier/capacitor for their circuit. They accepted my 4 gauge wire with no problem and tightened it neatly. I would buy them again if I had to as they worked great and kept my rig clean.

I bought this relatively cheap and it looks very nice and all the terminals were tightened when I installed my wiring but the only downside and why i gave it only 3 stars is the fact that the lid barely hangs when it snaps into place making it prone to falls and leaving the electrical connection exposed and could short out so it looks like i have to put it on tie the zipper to hold the lid as well, the rest of the device is neat.

I have this for both of my subwoofers that I ordered. Since I couldn't easily run two battery cables (well, maybe, but it didn't seem like much to me, plus lots of room). So I used a 4 gauge which was perfect for the amount of power I needed. This helped separate it just before the amps. I would recommend having a pair size allen wrenches to tighten it. It would have stayed in place. It did its job, holding tight to the power cords and passing power with no problem.

I liked the overall performance of the product when I received it but did notice that the top could be attached better. Looking closely at the plastic tabs that slide into the base, I noticed a few small pieces of plastic where they appeared to be in contact with the mold, preventing it from settling. In just a minute with a sharp knife I cut the tongues and was done. surprised how much safer it is. Now to take it off I have to squeeze it and then it pops out right away but now I can pull it…

Purchased for use under the hood with 4 AWG to disable the front battery and enable the rear amplifier. The booster burned out. Installation went well, finding a place was a problem, but the product is good. Depending on your application, you will likely need to provide screws. The screws bite well, the base is stable. Bought because the plastic lid looks like it will seal the joint - and it does it very well. Pros: easy to use, does the job well, small size. Cons: no fuse, no 12V indicator…