🚴 Enhance Performance with Sunlite Steel Quick Release Skewer for Rear Mounted Trainers Review

The total length of the narrow part is 167 mm. Nut at the end 15 mm. This leaves 152mm of space for the bike. The thin part has a diameter of 5 mm. Measure your axis. Some mountain bikes or cargo bikes may require a larger diameter skewer. I'm no expert but I remember reading this. May be. The skewer can end up going through the nut. That's why this skewer fits the width of most bicycles. This type of clamp is said to be better than the open mechanism type. I would like this information to be…

It worked for me in the end even though it's not much longer than my standard skewer. I had to add a baby trailer mount to the back of my Trek hybrid bike, but it already had a skewer barely long enough for the frame and 8 gears. I bought it hoping it would be 10mm longer than the original but it was only about 5mm. For now it seems safe, so I think it will work. The approximate width I need is 155-160mm. The closed length, measured from the inside of the lever to the end of the thread, is…

This quick release was purchased for the RAD Cycle Products Portable Indoor Magnetic Trainer (the one that came with the trainer was stolen along with the rest of my bike - they might actually may have been behind the bike, but you can't be sure these days). The quick release fits perfectly and works great in the trainer. From now on I will remove the quick release when I pull out my new bike - I don't want my bike to be the same target when thieves steal whole bikes just to get that shiny…