📱 Sturdy Aluminum Arm Mount Stand Holder for Tablet, Nintendo Switch, iPad, iPad Air, iPhone X, iPhone 8/7, Samsung Galaxy Review

The base doesn't have as much clip spacing as I thought looking at the pictures but I was able to get it to work. The big problem is that it just can't handle my tablet case because it's a bit wobbly. Luckily, on the rough side, it also has a velcro strap on the back that I can place on the mount, which allows the tablet's base to sit at an angle in the mount. Which seems to be working fine for the most part. In my opinion at least, it's a lot better than taking the tablet out of the case every

Recently Received. It is very similar to the Luxor lamp which I love, I have 2 of these lamps. This designer hand looks great on my bedside table. One small thing: you have to position the hand connection in the right direction so that the tablet/phone is directly in front of your face. I've connected mine to the back of a table and the viewing area isn't directly in front of my face but at an angle. The design of the ball holder does not allow viewing from such an angle. Otherwise it's still a

My tablet is heavy. I don't take the case off because it hurts to take it off. If you are using a heavier tablet, remove the case before using it, otherwise the tablet holder will sag and the tablet will slowly tip down due to its heavy weight. Apart from that fact I like it. I have one for my microphone on my desktop and it works great. Compared to the more expensive ones, they work perfectly. I just wish they were a little longer!

I bought a tablet mount for the sole purpose of using it with my Nintendo Switch. It works great on my desk, but I chose to mount it horizontally on my headboard so I can use the system in bed. Since this mount wasn't intended for this use, it just didn't work. assembly instructions. The handle "hand" has a ball joint, which must be unscrewed and inserted into the gap, then tighten the fasteners. You then attach the "arm" to the end of the arm with a light clamp joint. The vise can be attached…

I've tried several flexible metal cord holders over the years. I love that I can use my e-reader in bed without holding it to my face. When I fall asleep, they don't hit me in the face. The benefit is a more durable feature, it doesn't jump like a rope. The downside is that it's shorter than my last 2 rope holders. It's too short even when mounted on a bed frame. It would be better if both sections were about 6-8 inches longer for better reach without having to press against the edge of the…