Header banner
Revain logoHome Page
💨 tailonz pneumatic fitting connector pipe (10pcs): streamline your pneumatic systems logo

💨 Tailonz Pneumatic Fitting Connector Pipe (10Pcs): Streamline Your Pneumatic Systems Review

3

·

Poor

Revainrating 2 out of 5  
Rating 
2.0
🔧 Fittings, 🚰 Hydraulics, Pneumatics & Plumbing

View on AmazonView on ЯM

Media

(4)
img 1 attached to 💨 Tailonz Pneumatic Fitting Connector Pipe (10Pcs): Streamline Your Pneumatic Systems
img 2 attached to 💨 Tailonz Pneumatic Fitting Connector Pipe (10Pcs): Streamline Your Pneumatic Systems
img 3 attached to 💨 Tailonz Pneumatic Fitting Connector Pipe (10Pcs): Streamline Your Pneumatic Systems
img 4 attached to 💨 Tailonz Pneumatic Fitting Connector Pipe (10Pcs): Streamline Your Pneumatic Systems

Description of 💨 Tailonz Pneumatic Fitting Connector Pipe (10Pcs): Streamline Your Pneumatic Systems

【Product Name】Female Thread Barb Fitting【Material】 Brass. 【Size】3/8" Barb to 1/4" Female NPT. 【Temperature Range】 -40°F to 160°F【Maximum Pressure】150 Psi. 【Premium Material】Brass barbed hose fitting is made of high quality solid brass, firm and durable, providing high resistance to abrasion and corrosion. 【Typical Application】temperature Control Circuits,pneumatic Circuits,vacuum And Fluid Systems Test Apparatus,lubricant,coolant Lines.

Reviews

Global ratings 3
  • 5
    0
  • 4
    0
  • 3
    1
  • 2
    1
  • 1
    1

Type of review

Revainrating 3 out of 5

Extremely Small Barb Diameter

These connectors border on a very small diameter. The women's versions I ordered were significantly closer to 1/4" ID than this one. They were shown side by side. I think some cost cutting has been done here and that's not a good thing. Pinching when tightening.

Pros
  • Typical Application
Cons
  • Wrinkled Packaging

Revainrating 1 out of 5

Notch in hydraulic, pneumatic and plumbing too small

Used for 3/8 inch diameter compressor hose. Work with the included hose clamps or crimp connectors I bought. The hose clamps that come with the fittings strip when tightened, making them useless as well. Now I'm sending them back and looking for another manufacturer. Tailonz needs to check the quality of their products a little better.

Pros
  • Product name
Cons
  • Some small things

Revainrating 2 out of 5

Machined nicks ruin an otherwise good product.

These might work. I've had to replace the lines that go to the bottom valve on a Trinco blasting chamber and it's easier to just make new ones than to buy new ones. There is definitely cost cutting going on here, and not in a good or safe way. The serrations have been machined so that no force is required to insert the fitting into a 3/8" ID air hose. See the circled areas in the attached image. For reference, the upper fitting was purchased from Lowe's. Will it withstand 80psi , we'll see…

Pros
  • Premium Material
Cons
  • Write Later