🚗 Durable and Reliable Ten Factory MG21102 Dana Axle: Upgrade Your Vehicle's Performance Review

Passenger side seal diameter does not match XJ or YJ with two piece passenger side axle shafts. If you want to use these you will need to do a one-piece axle shaft rebuild.

As advertised make sure to send them home when you install them! I used a 2X2 piece of ash wood with a hammer. The first one I installed wasn't deep enough and I had to pull the axle out again. Then I drove it in until I was out. As you can see in the photo, the gap from the yolk on the axis is not large. Yes, I upgraded to 1350 yolks, which is more than stock. Much luck!

They're great for storing all those nasty things I drive through from my jeep axles. When I cleaned the axle tubes before installing them, I was shocked at how much dirt there was in the tubes. As long as you keep them lubed, they will keep all those nasty things off your axle tubes. Very easy to set up in the afternoon. Takes about two hours. I would recommend removing the diff cover, replacing the axle seals, inspecting the entire body and cleaning the entire axle of dirt.

It was a pleasure working with the seller, he happened to send me the wrong batch, processed quickly and sent me the correct package . The product is of excellent quality and easy to install. It is recommended to use a wire wheel or sandpaper to clean the axle shaft where it will move in the seal. Put some lube on the rubber end where it enters the axle tube and make sure the lubricator is easily accessible. I used a 2x4 section to put them on the axle. Then apply some assembly grease to the…

Received these very quickly and was initially impressed with the build quality. They also seem to be well thought out in terms of design. The cases have aluminum construction that is rubberized and then has a rubber insert and I think aluminum that snaps in too. Before I did anything, I checked that the body shell was seated and loose in the axle tube on my 1972 Jeep CJ5. Not just a little, but a lot. I thought these were made for Dana 30 axles? What about it? Anyway, I really want to keep dirt

They are really good. Put them on my 2007 JK front axles. They won't fit if you have axle tube bushings, so FYI. Otherwise they are very easy to install. You will first need to cut the plastic protection off your existing axles at the U-joints and then remove the axle guides to get the axles back up. Lubricate them after reinstalling the axles. the C is on the back so I had to pull out the mirrors and use the rubber tip on the grease gun. I pumped up the grease until it came out, then put the…