Header banner
Revain logoHome Page
πŸ”Œ rareelectrical 12v solenoid with 3 terminals for trombetta - compatible with part numbers 852-1221-210, 854-1221-210, and 8541221210 logo

πŸ”Œ Rareelectrical 12V Solenoid with 3 Terminals for Trombetta - Compatible with Part Numbers 852-1221-210, 854-1221-210, and 8541221210 Review

4

Β·

Average

Revainrating 3.5 out of 5Β Β 
RatingΒ 
3.3
πŸ”‹ Starters & Alternators, 🏎️ Performance Car Parts & Accessories

View on AmazonView on Π―M

Media

(1)
img 1 attached to πŸ”Œ Rareelectrical 12V Solenoid with 3 Terminals for Trombetta - Compatible with Part Numbers 852-1221-210, 854-1221-210, and 8541221210

Description of πŸ”Œ Rareelectrical 12V Solenoid with 3 Terminals for Trombetta - Compatible with Part Numbers 852-1221-210, 854-1221-210, and 8541221210

100% NEW and Made with the Highest Quality Components Available. Full One Year Warranty. Computer tested for consistent Quality and unsurpassed reliability. Solenoid - Voltage: 12V Terminal Count: 3 Source: Aftermarket.

Reviews

Global ratings 4
  • 5
    1
  • 4
    1
  • 3
    1
  • 2
    0
  • 1
    1

Type of review

Revainrating 1 out of 5

Avoid this product - it sucks

The solenoid was bad and cost me a lot of unnecessary work, worry and money. My mechanic bought another at the local Brigs store and the mower started right up.

Pros
  • practical item
Cons
  • Ugly packaging

Revainrating 3 out of 5

Lasted 7 months best at Starters & Parts

So mine lasted 7 months and it failed, the company just immediately sent me an RMA for an exchange. Will be updated with customer service and/or when a new one fails. I wish the mower manufacturers had put them somewhere cheaper!

Pros
  • Test for a year
Cons
  • Quality

Revainrating 5 out of 5

Ideal for spares

Can't comment on durability yet as it's only been up a few weeks but seems to be working great. I put it on an 11hp go kart ken bar to replace the original after it won't start just click click click.

Pros
  • Best
Cons
  • Appearance

Revainrating 4 out of 5

The only problem was that the existing bolt diameter was too large.

The only problem was that the existing bolt diameter was too big for the new solenoid. All I did was take wider and wider flathead screwdriver sizes and twist them around to widen the receiving holes until the studs fit. Total processing time 3 min. There will be a continuous performance.

Pros
  • Free for educational purposes
Cons
  • Not sure