Trailer Bearing Repair Kits for 1-1/16 Inch Straight Spindles - Set of Two Review

So the bearings and raceways worked fine. The seals didn't fit. I had to run across town to find the right ones. The seller had to leave the seals and indicate them.

Use these on my boat trailer and they are exactly what I expected and more. The double lip seal is the best kit I've ever bought and I've seen all sorts in over 40 years of boat and trailer repairs. I'll come back here from now on.

So far so good. Installation was easy with standard shop tools. Instead of using a press to install races, I cut out a few used ones with a grinding wheel and use them to install new ones with a hammer and block. The incisions made it easier to remove

Fits perfectly Never used bearing cap. I installed bearings. Maybe they could make that an option. But they seem to be of good quality and I had no trouble installing them and they are cheaper than your local parts store plus shipping direct to your door.

Ordered a bearing to replace a bearing in a boat trailer wheel, the same Chinese bearing that was removed. The seal was 1.25 inside and 1.98 outside, the same as what was inside. great fit. The preloaded bearing got the boat about 50 miles fishing after installation and no problems. will be updated if something goes wrong.

Excellent value for money. The components are standard bearings and rings that are readily available locally, but it's nice that it all comes together at a very good price. My only problem was the oil seal didn't fit my boat trailer axle/hub. The included grease seal is 1.25" ID and was supposed to be 1.375 ID (SFK 13557) so I had to buy it locally.

I've never fitted bearings. Work is a challenge, but a welcome one. At first I thought I would refuse to replace the races, but I'm glad I didn't. From the moment of installation everything was fine and if I had to buy them again. For the record, I tow a 9.4 bass dog on a light trailer, so I don't actually cook him a hot dinner.

This is the second order for two trailers. One is a Karavan Utility Trailer and the other is a 1996 Dutchman Pop up Camper. Both fit and work great. Before ordering, check the stock and race numbers stamped on the old part to ensure proper fitment. The kit comes with everything you need to get the job done except the lube. Would buy again if needed.

Used on a TSC-purchased Dexter straight-axle carry-on tag. I didn't want to pay an insane price for each page. Carry-on costs about $50 ($100) at TSC. Local stock required even more at $78 per side ($156). It fitted perfectly, the bearings were good quality and had all the necessary parts (except for the oil seals, which is a shame because there are good ones in the kit). Doused her with red high temperature and immediately went on a 1100-mile journey with a full charge. Worked great and didn't