I like that it works well and doesn't try to thread the pipe instead of cutting it like my backup pipe cutter did. It's nice and solid and it works.

Used to cut SteelTek structural steel (black). I made about 6 cuts and only one was crooked. I am a large freakishly strong person and it might have been impatience or lack of skill but I would not say this "cut steel like butter.” If I had to make more cuts than 5-10 for my project or felt I would use this more frequently, I would definitely consider a higher grade version for steel.Ultimately for this single project I’m happy I didn’t have to spend $50-$100 on a single-use tool to cut $50…

Very handy. Very sharp. I used this tool to cut half inch EMT. It did cut metal pipe in 3 twists. Amazing! I see an extra blade attached to this cutter.

I bought this pipe cutting tool to cut the top rail of a 10x10’ chain link fence panel that had rusted. These portable panels are part of a dog kennel system. I have many of them and some have rusted and are hazardous. This tool was sooo easy to use. I’m a female and was not looking forward to hacksawing this piece off in 2 places. It would’ve took me 15 mins. I ordered this tool for the amazing price of less than $20. It took just 10 turns of the tool around each end and it popped right off…

I purchased this cutter to cut 1" PVC, not realizing before I purchased it that the cutter wasn't deep enough to work on PVC. I tried it on 3/4" copper tubing and it cuts OK. OK, not great. The built-in reamer is underwhelming. Not a top quality too, but it's not at that price point. The spare cutter is under the screw that holds the cutter adjustment know. If you have only a few cuts to make or just want an emergency backup cutter, this might be a good purchase. I would NOT want to use it for…

Provided blades will not cut anything. Tried to use it right after receiving it, blade within wont work. Swapped to second blade provided. Wont work.You basically receive two blunt tiny discs of flimsy junk.

This pipe cutter is made to such loose tolerances that it is basically impossible to get a clean cut. The cutting wheel is loosely attached and wobbles from side to side. After the first revolution, the cut has diverged from its initial position on the pipe.

If I did this more often I would buy individual sized cutters. Sometimes a little awkward and impossible to ensure you’re completely straight so just have to eyeball it. Worked well though overall and was inexpensive

Used this to trim 1/2" off of a set of irons and it worked flawlessly. The finished edge looked factory and was very smooth. Highly recommend.

This product is made with very cheap material. Unable to adjust easily and the blade is brand new and dull. VERY DISPLEASED!