🚙 Spare Tire Mount for Jeep Wrangler JK & JKU: u-Box CB Antenna Holder (2007-2018) Review

I hate writing bad reviews and have seen some real crap lately. First of all, it's not stainless unless it's a 400 series, which I really don't think so. It won't clean the spare tire, at least not on my stock JK. You can get it to work by using 2 x 1" spacers and two M8x1.25x 45 screws and placing it on the opposite side and back. I did that. The edge the antenna runs over sticks out nicely 3/16" out the back door. Okay, it's too thick and the powder coating seems well done. There are no sharp

Attaches to the spare wheel carrier using existing Jeep bolts. The problem is that after reinstalling it on the trunk, the antenna gets pinched by the spare wheel. The antenna is opposite the OEM spare wheel, which also causes wear and SWR issues. I'm going to add some washers to the spare tire holder to make room between the spare tire and the antenna. I am attaching some photos to show the clearance issue. By the way, I use a thin hamstick antenna. One of the photos shows where the antenna…

Great vehicle. I installed on my JKU 2014. I also have a spare spacer for my 35x12.5 spare. This mount fits perfectly. You will need to sand down the powder coating underneath the top antenna hole and outside of the two screw holes. This provides a good chassis ground and saves me from using a ground strap as I originally intended. If your build is similar to mine, you will need longer screws (M8 1.25 with 13mm thread) and six washers to install this straight. Two flat washers at the bottom and