🔧 Ultimate Pack of 30 Pcs 8mm Hole Retainer Clips: Premium Plastic Drive Rivets for Nissan Bumpers - uxcell Review

Working as expected. Yes, a few of these broke, but there are enough of them in the pack. So I am very happy with the purchase. Thanks seller!

I need to replace a rivet on my front passenger side bumper. The ones in it do NOT work. You are wrong. I had to go to the dealer to find the right one. Everyone on the net is wrong

I bought these for my 2014 Nissan 370z. Protection under the front wheels has been weakened. I put these new ones in and took out some of the broken ones and replaced them. The protective case is now durable and the clips hold tight. These clips can also be used to trim the engine compartment.

OEM specs at about 75% off what they sell in auto parts stores. I work a lot on my car so over time they break down and need to be replaced. I took this kit and replaced all the missing and broken parts in half for future use. If you have a car and you service it yourself, get one of these kits. You will not be disappointed.

Just received clips for my 2010 Nissan Rogue. Install them on the bumper and other places where clips are needed. Clips work very well, look very strong. I recommend buying these clips. One point that some people may not be aware of is that you have to loosen the middle part of the clip with a small screwdriver and then pry the clip out of what it's holding. If I ever need clips again I will definitely buy this product.

I used them on a 2010 Nissan Versa. They fit perfectly! This is a great quality product and they work just as well as the OEM clips. You're bound to break a few original clips while servicing your own car (those damn things are used throughout this Versa!), so I highly recommend them if you need to replace them. They're cheaper and better than what you'll find at any auto parts store, trust me. Update: over a month later. Still going strong and I still recommend them! They've lasted longer than

Bought this fender liner for a 1999 Honda Odyssey. They are slightly different in design from the original Honda parts, but fit the holes better. It took a lot of effort to get the OEM part back and I broke as much putting them back in as I did removing them. They were really easy to hit because the sides are smooth when not locked. The pointed tip really helped align the holes, especially when you need to align two covers with a hole in the frame. I highly recommend them and I won't even try…