🖤 Walnut Hollow Creative Hobby Tool: Ideal for R/C and Plastic Modelers in Sleek Black Review

I bought this to cut templates out of 6mm mylar. Two hot knives were useless. I waited for the tip to get hot enough, but that never happened; The stem of the nozzle only smoked for about 15 minutes until I turned it off and changed the tip. Luckily the brass conical cone was just the ticket and I quickly pumped up and completed the large intricate template in a matter of hours. My favorite tip is to put the tracing pen under the glass pane and Mylar on top. Then there is no need to repeat the…

I bought this tool after my previous one broke. Creative Versa Hollow Hollow with Versa-Temp Temperature Control My old one was a little better but this one still fits my needs perfectly. The grip gets too hot for my hands and the grip is not as comfortable as my old silicone grip. Old: had a temperature scale (you can set the temperature from low to medium). I often trip over the dial and accidentally turn the heater up or down without realizing it (until it's too late). This one: no…

Years ago I had a wood burning tool that made it a chore because it took so long. Now I understand that this is due to the low performance of this tool. When I first started looking for something to cut mylar stencils I needed a versatile tool to do more than one job. This one seemed just right. I pulled it out for the first time two nights ago and cut out three large templates to use with my Gelli plates to create gel prints. I figured a utility knife blade would do, but it was incredibly slow