WMPHE 2 PCS ABS Wheel Speed Sensor Front Left & 🔧 Right for Jeep Wrangler 3.6L 3.8L 2007-2017 | Replaces OEM 68003281AC 68003281AA Review

These sensors are not original but you get 2 sensors for much less than a single original OEM sensor. All rubber grommets and plastic clips for mounting or attachment perfectly match the original locations. Also, they fixed/cured the ABS/TRACTION CONTROL LIGHT which is why I made the purchase in the first place. Let's see how long they last because as far as I know wheel speed sensors routinely fail on these Wrangler JKs.

I replaced the ABS sensors on my 2015 Jeep Wrangler JK with these parts. They are exactly the same as OEM and come with dielectric grease. ABS sensors fail in the Wrangler, unfortunately this is a common problem but this part fixes it. Good luck getting the old sensors out without damaging them. If you live in the Rust Belt, you probably will. I soaked the old sensor in the PB Blaster, drilled a pilot hole, put a screw in and pulled the part out.

I had the infamous ABS, VSA warning lights on our Jeep JK 07 with 3.8 engine. I found codes that lead me to the wheel speed sensors. I replaced the front and rear as well as the front bearing on the passenger side axle. This solved the problem. The front wheel is the first thing to fail on these jeeps. probably due to the amount of dirt, mud and pavement they get on the overtaking side of the car. Start on this page first or just replace them all and you won't have to worry about finding…

When I tried to remove the factory part I broke it so I had to drill a small hole in the center about half an inch deep then drive a screw in and use needle nose pliers. Grab the screw head and pull out the defective sensor. Before replacing I cleaned the hole of dirt and made sure you use the small red O-ring of the original, the replacement sensor is not included. I also applied a small amount of marine grease to the base of the sensor (not the sensor itself), carefully slipped the new part…