Wolfride Rabbet Router Bearings Replacement Review

Waste of money. They will NOT fit 1/4" shank bits. They are too small. You cannot make them fit. It is not clear what they are for.

They work just fine for me. I use them on guitar whistles where even small errors are unacceptable. In such a situation, they work well.

Helped me complete a project. These bearings are not all from the same brand. It's a mix of brands. Some of them were decent quality and some were not so good. Would give 3.5 stars if I could.

I use this in a vise as a blade balancer. Works perfect! Compared to the chunky cone-shaped balance wheel, there's no comparison. My mower blades are really balanced now and my mower feels that way now. worth your money

first use Milling a small tongue into a thin piece of plywood I was unable to attach a backing plate and the drill went too deep as the bearing flexed slightly. MY DEBT! wide range of sizes, lots of screws to fix, a good accessory for my router

Bought this last week for a special project I have along with some parts. Less than six inches of work and the bearing I used from the kit blew apart. My old racquet was the same size and I used this one instead. Cut 40 feet of faceplate with no further problems. I wouldn't give them any stars but it looks like I'll have to give them one. I'm sure I'll be disappointed with the Wolfride bearings and will be returning them for something else!