🐠 Enhance Your Fluval Edge Aquarium with Zanyzap Pre-Filter Sponge 3 Pack! Review

For me it was perfect. I have an AquaClear 30 and an AquaClear 70. I have two heavily planted tanks and am tired of pulling the plants out of the intake tubes. I was also concerned that the augers would enter the tubes and eventually damage the impeller. They also help a little with biological filtration. The sponge glides well over the AC 30 tube and to my surprise the sponge sits well on the cone of the AC 70 tube. Overall this is exactly what I was looking for. Yes they are small but I…

They are perfect for my HOB water filters for my Betta aquarium. I bought them for several reasons-1. to reduce the filter flow. I have a small aquarium and was concerned that the current would be too strong for my fish. I don't notice a significant reduction in flow, but I believe it had a minimal effect. 2. Large debris that normally gets sucked into my filter seems to end up in the pre-filter sponge which is easy to remove and rinse out. This helps extend the life of the filter as it doesn't

Purchased for use with Fluval C3 Inlet Filter; Firstly I was expecting baby shrimp from a couple of my berry shrimp I had and I needed something to block the inlet to keep them from being sucked in and secondly after the poly filter had clogged a few since I had the Fluval C3 (indicator sticking out) About a week or a week and a half between replacing the polypropylene gasket, I decided I needed a pre-filter that I could easily clean to extend the life. Replacement of filter mats in the HOB…