🚗 Alpinetech 15.5-Inch Quarter Round Spoiler Light with LED 3rd Brake Light Review

The price is a bit high but it fits the Snug Top well after I open the wire hole. The original light has lasted for many years so if I live 5 good years from this I will be happy. Installation involved removing the original light, removing the old silicone/RTV, wiping the contact surfaces with alcohol, applying a few drops of exterior silicone and sliding the light into position. Some people use double sided tape but I used high quality silicone. Wiring was easy: just cut two wires, stripped…

Put on my snap like it was made for him. Actually I think the one I took from the Snugtop was an older model of the item. I used my truck so I don't know if it was the original OEM I replaced or not but it worked great and took about 20 minutes to replace. Most of the time the replacement was spent removing dirt and old glue that had hardened underneath the old one. The profile isn't quite what I would describe as a "quarter round" but I could see where it really describes the shape. If I still

Here are some installation and viewing instructions. The block itself works fine. we'll see at the next heavy downpour. Just bean counting would be nice if there were instructions, but this is how I made it for the camper body. In my case it was a slim top. It sounds like a long time below, but it was only about 45 minutes for someone with a basic knowledge. To remove your old brake light, pry very slightly and pull out. If it were as old as mine, I could just use my hands. Most likely the…