🔧 Dasen Engine Install/Remove Tool Kit for Ford 4.6L/5.4L/6.8L 3V V8 – Timing Chain Locking, Cam Phaser Holding, Cam Phaser Lockout, Pulley Bolt & Crankshaft Positioning Review

The description says that it is compatible with 3V, in short it is unlikely to be the case and you should look for another brand where the compatibility not specified in the product description. My best one line advice I can give is: the item in question must be a fake as it is not a technical model. To put it mildly, I wasn't impressed.

engine installation 5.4 3v 6.5k latest intsalled ford cam followers with small oil port on the ends, this tool worked perfectly, after a little stuffing at the shaft where the collar slides up and down it sticks. You read that another brand is bent, this brand is rustproof, more elastic. I would buy this product again. Stainless metal, more like spring metal that springs back to its original shape when squeezed and released. Would buy again even though I had to use a bit of metal fill.

I was concerned that buying one of these tools might damage it. Here's what I can tell you: 1. Pay close attention to the orientation of the stem that rests on the valve spring. Make sure it has slack to move down so it doesn't break. If you push it against another valve or ledge you'll ruin it. That's a lot of pressure. 2. Use a 5/8 wrench to tighten and loosen. Use one hand to place your foot on the valve and the finger of that hand to hold the rocker arm against the valve when it's…