🔥 Enhance Your Jeep Wrangler JL with FieryRed Smoked LED Tail Lights: Reverse Light, Turn Signal, and Running Lights for 2018-2021 Models Review

Bought these for my 2018 jl and they set an active code which the retailer couldn't clear. They sent a second set, same problem. Every time you start the jeep, a code will appear asking you to turn off the turn signals. Fast flashing on the dashboard but the exterior light works fine. Offroad 4x4 didn't help at all. Don't waste your money if you don't want a big hassle.

When I first bought it at such a low price, there were reservations about the actual brightness of the braking function. I'm perfectly happy with that aspect of them. They don't come with instructions. There are videos on YouTube that simplify the 10 minute installation. You must remove the brackets from the stock lights to fully secure them with factory hardware. The ONLY thing I don't like is that there is no reflector to make them safer when parking. There were no problems with codes and…

Good product. Easy to install once you understand how. First, remove the backing of your existing OEM light and install it on your new LED light. Second, make sure you also remove the metal clip that is on the factory bulb to proceed with the new LED bulb. Second, you need to attach the clamps that come with the metal bracket to the bracket on the non-hole side. The resistor is screwed to the metal bracket and should not be close to the wires. It can reach 300 degrees when the light is in use…

I'm posting this for 2 reasons: 1. Where to put the resistance mount? 2. Lightweight 1. Installation is easy, just open the cover on the inside of the jeep next to the cross member with a flathead screwdriver to access the locking bolts. Remove the plastic screw using the torx tool that comes with the jeep. When you turn off the light, unplug the wires and remove the 3 screws from the extension bracket on the original light and then put it on the new LED light. On the new light I installed the…

2020 Sport Altitude (no rear security package) - I ordered a variant with a side marker light mounted in the center where it is blind on pricier jeeps Spot monitoring system . . Put them on an hour later once they arrive. Like most LED lights used with CanBus style vehicle control systems, RESISTORS always seem to be the Achilles heel of such products. Of course, their job is to siphon off extra power from the body control module so the car's computers don't warn on the dash that the light bulb