The tool is inaccurately sized and very poorly finished! When did I try to grind it down to the thickness I needed? I found that the tool is made of inferior materials.
Reliable little tool. I had to shave the tip off a bit to get it into the slot I was trying to tighten (the oil pressure relief screw in the VW Beetle engine). I ground it up on a grinder with a tungsten grinder and I can tell you the material it's made of is REALLY hard. The fresh tungsten grinder had a hard time grinding it and it took a long time considering how little I removed. It should take a lot of abuse.
The quality of the drawing seat is good. This is used to loosen the screws on the rear seats of a Porsche 911 993. When researching this part I expected the width of the flat nozzle to fit, but it turned out to be larger than expected and it doesn't fit. I wish this list had a chart or picture of the measurements for this outlet. Would be helpful. It might work if I write it down, but I don't have the tools/patience for it. Let's move on to another option.