Review on Enhanced Printer Filament: Vibrant Colors and Premium Material by Jacob Ferrarini

Of all my filaments, this one seems to have a Z spacing issue on the supports. Every single thread I use can break out of supports with a support interface and a spacing of about 2x the layer height, except this one. This one almost welds to the support interface and won't snap off no matter what, so any bottom that has to be supported from every single print with this stuff has been awful. The top of these prints was great, the build plate grip was great, and the spool wound up well. The only problem I had was the lugs and supports, the settings of which worked perfectly for ANY OTHER TYPE I HAVE (e.g. 8 other filaments from 5 different brands). So something is clearly wrong with this thread, I can try other print temps well below the "allowed" temps listed and see if that helps.