Enhanced Printer Filament: Vibrant Colors and Premium Material Review

I received my Gold Silk PLA last night and immediately started printing some trophies for the tournament. After reading some of the other reviews I was concerned that I might have some issues that others had. Nothing is further from the truth! I think this is one of the easiest and highest quality filaments I've ever run through my printer. Look at the attached picture. I haven't done anything to clean or fix the print. No stains, clogs, puckering, warping, or other issues stemming from crappy…

Looks great on roll, not so good on print. more like yellow toffee. The print quality was average, if you increase the temperature to get better flow with good print quality it ends up getting a bit darker. Setting it colder will make the print closer to gold, will have some imperfections, if you sand this you will need to sand and polish very well to get the color back. I will give an update later to see if it changes in the next prints. I also bought a silver one from the same company.

Of all my filaments, this one seems to have a Z spacing issue on the supports. Every single thread I use can break out of supports with a support interface and a spacing of about 2x the layer height, except this one. This one almost welds to the support interface and won't snap off no matter what, so any bottom that has to be supported from every single print with this stuff has been awful. The top of these prints was great, the build plate grip was great, and the spool wound up well. The only…