Review on Anderson Metals Fitting Reducing Nipple by George Johnson
Not so with the size.
I have an Anderson Metals brass tube fitting, reducing hex nipple, size 1/2" male x 1/4" male to fit it to my Paasche compressor because it fits. was defective and finally blew me away. This item has arrived and the 1/2" side has a 5/8" ID therefore the outside diameter is larger, due to physical reasons. So not even close to 1/2 inch, whichever way you look at it.
- Industrial & Scientific
- Available in black only
New products
Comments (0)
Top products in π§ Fittings
Joywayus 5/8" ID Hose Barb Hex Union Brass Fitting Water/Fuel/Air With 10 Stainless Steel Clamps (Pack Of 5)
13 Review
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review
Upgrade Your Draft Beer Kegerator With The TerraBloom CO2 Keg Pressure Regulator - Dual Gauge Heavy Duty Unit With Safety Features
16 Review
6 Pack Miahart Adjustable 304 Stainless Steel 4 Inch Hose Clamp Duct 91Mm-114Mm Worm Gear Pipe Clamp For Automotive, Mechanical Agriculture.
18 Review
