Review on 🛏️ CHPOWER Creality Removable Ultra-Flexible 235mm x 235mm Print Bed by Matt Conner

I really liked the magnetic bed on my Ender 3 Pro. Adhesion is excellent, although printed skirts tend to leave their ghosts in the textured surface over time. Ugly, but it can actually improve adhesion a bit. Creality warns against layer operating temperatures above 80°C in order to preserve the magnetic properties of the layer material. Several YouTubers have run it at 100°C for ABS and claim that this hasn't affected the magnetic properties of the bed material. I will be working on a project with ABS soon and wanted a spare in case they make a mistake. Which of course is impossible. If it's on YouTube, it must be right, right? Edit: I said in the title that this is exactly the same as the original. However, I just tried it on my Ender 3 Pro and it's not exactly the same. I installed the bed material on the original magnetic surface and it doesn't magnetize as much. It's not necessarily bad. The original is too strong and difficult to reinsert once removed. I think he always wants to put a few millimeters to the right because the magnets are aligned. The new one doesn't have this problem as the attraction isn't as strong. He goes where I want. It's still strong enough to stay in place and lay very flat. I am still very satisfied with the product.