Review on 🔘 1.75mm Taulman Black 645 Nylon Filament by John Bennett

nylon, after curing there are very good prints. Like any nylon, you MUST dry it before use. My main complaint is that the outside diameter of Taulman3D filament (in my experience) is always very different from specification, sometimes being as little as 1.65mm and often having an oval cross-section. So before printing I have to measure the OD of the filament in both directions and then adjust the slicing settings based on the test prints, which is an unwanted problem. Taulman needs to improve on this as there are now some good nylon competitors with true 1.75mm OD.