Review on 🖨️ BUMAT 3D Printer Filament for Enhanced SEO by Frank Harwood

My first print with this filament at 195°C was very bad, the layers were brittle with poor adhesion. Compared to another brand I've used before (I won't name them here), I had to crank this thread to 210C and set the flow rate to 103% to get good layer adhesion with adequate side hoop strength. Once I did that, the part printed fine. If you intend to purchase and use this grade, be aware that it may need to be extruded at a higher temperature than the PLA temperature range to achieve good print quality.