🖨️ BUMAT 3D Printer Filament for Enhanced SEO Review

The filament is stuck and won't feed at the end of a long print. The thread is crossed in such a way that it is not being fed properly. This is my second role and both had issues. I will not buy this brand again.

My first print with this filament at 195°C was very bad, the layers were brittle with poor adhesion. Compared to another brand I've used before (I won't name them here), I had to crank this thread to 210C and set the flow rate to 103% to get good layer adhesion with adequate side hoop strength. Once I did that, the part printed fine. If you intend to purchase and use this grade, be aware that it may need to be extruded at a higher temperature than the PLA temperature range to achieve good print

I ordered this product expecting it to be like "Silk Silver" with a metallic sheen. It's not, but it's not the product's fault, I just misread the description. (I'm new to 3D printing). The thread is only light gray. It's fine for everyday typing, but I wouldn't overstate it. Now for the thread itself: it was vacuum packed with a desiccant bag, so it arrived as fresh as it came from the factory. I used over half the spool and printed everything from rough prototypes to miniature action figures.