Review on Forito 2-Pack 15.6 Inch Laptop Screen Protector: Blocks Blue Light And Reduces Glare For Eye Protection On 16:9 Aspect Ratio Laptops by Paul Stocks

I just go this in the mail and installed it right away. For reference, I have the 2019 HP Envy x 360 (15.6 in). The instructions were very minimal and a bit confusing (its the same instructions found as one of the photos).Basically:1) Clean it and remove any fuzz or debris so it is clean (like how you do it when you are gonna put a phone screen protector)2) Remove the cover from the thin plastic sleeve it is in3) Before you remove the "Tab 1" label, its best to see where you would like to start and that it fits your screen properly.4) Slowly peel back the plastic by pulling the "Tab 1" ( It will be a bit sticky, be sure to not touch it) Line it up with your screen and place it5) Peel back the rest of the covering and slowly put the screen protector on to the rest of the screen6) Lastly, remove the bubbles with the device they give you and then remove "tab 2" to remove a second film of covering to reveal the screen protector beneath (when I did this, the "tab 2" sticker was removed but the plastic cover over it didn't. I just removed it now).My thoughts: Over all, so far so good. Not super easy but, easy enough. The only thing is that this was my first time installing a screen protector so it is a bit off which isn't a problem. Touch screen works fine there isn't an issue. The quality the text looks fine nothing seems to be blurry. The edges of the screen protector are rounded while the edges of my screen have defined corners, but that's not an issue for me but if it is for you, you might want to reconsider. Would be better if the directions were easier of if there was video directions. I any changes occur while using it outside/ at school, I'll be sure to add any updates, but so far so good.