Review on 🔩 Polymaker Filament PolyDissolve: The Ultimate Dissolvable PolySmooth Solution by Omar Svagera

I bought this material thinking it would save time/effort on my prints but instead it ruined the hot part of my printer 3 times . First print was fantastic, just a direct test. Then the second went bad. The print start was in place, but when left unattended (about 9 hours of printing) I reverted to material sticking out from the edge of the track. Material clogged at the end. and I blamed it on operator error. Another test print and I thought it was right. A few hours later another imprint. The same result. This happened over and over again, going through temperature ranges of 5 degrees at a time. Luckily I had multiple ends, had to rebuild the hotend 3 times and spent almost 2 days trying (unsuccessfully) to get a working result as a full print base.