🔩 Polymaker Filament PolyDissolve: The Ultimate Dissolvable PolySmooth Solution Review

I've been waiting for this thread for a long time. A lot of groundwork was done prior to the release of this support material. I use it with Mosaic Palette Pro and primarily wanted to use it with PLA. Try it out of the box first and the filament will not stick to the PLA. Instead of laying down and sticking to the underlying PLA layer, it doesn't stick well and starts to stick together and fall off the model. For an expensive support material designed specifically to work with PLA, this is a…

As the absolutely truthful Revain reviewer previously reported, using this thread with Chroma requires the material settings to be set to 6-2-8. If you do this, it works great. I didn't have any of the splicing errors that occur when leaving settings 0-0-0. No traffic jams. No questions. It's absolutely reliable. When you pull it into Palette 2 from the bottom, make sure it's as close and short as possible. Otherwise he will have problems with the passage. I hope it comes up for sale again. I…

I bought this material thinking it would save time/effort on my prints but instead it ruined the hot part of my printer 3 times . First print was fantastic, just a direct test. Then the second went bad. The print start was in place, but when left unattended (about 9 hours of printing) I reverted to material sticking out from the edge of the track. Material clogged at the end. and I blamed it on operator error. Another test print and I thought it was right. A few hours later another imprint. The