Review on Comgrow Filament Drying Box With Filament Holder And 2 PLA Spools, 1.75Mm Diameter, 1Kg Capacity Per Spool - Ideal For 3D Printing Filament Storage And Protection by Luis Norman

New to 3D printing - wasn't sure I really needed a dryer box like this. But I did want the two rolls of filament that came with it. Turns out the dryer box is a necessary accessory. I printed an object with filament that had set out for a few days and then printed the object a second time with the same filament after it went through a cycle in this dryer box. Noticeable difference. The dried / dehydrated filament produced a flat print - whereas the object using the unprocessed filament had defects and one corner that was slightly raised.The filament that you get is adequate IMO. Fairly shiny. Feels a bit less dense than some other filament I purchased.I'm very happy with my purchase.