Review on Sawing machine Makita 2704N, 1650 W by Mateusz Uliasz ᠌

But in the end I had to fake it, because. there is a defect in the casting of the casing, therefore, the front and rear parts of the disk differ by 4 mm relative to the parallel stop, so I had to put a 4 mm insert under the rear upper stop of the engine. After the alterations, it became very convenient in pruning, dissolution and sawing! Pros: 1. Quick adjustment, both in height and angle, as well as in the rip fence. 2. Good removal of sawdust. 3. Good native drive. Some cons: 1. Got which is made in the USA 2. Defective casting of the disc casing, because of this, the disc is offset relative to the parallel control (+ -) 4 mm, meaning its front and rear parts. 3. Plastic disk case. 4. The price seems to be slightly overpriced. 5. The absence of a table in the configuration. For this money, and I took it about 23,000, it would be possible to provide for at least some simple one.