Review on 🔧 2-Pack of 4SHANK×2 Grinded Machine Slotting Bits by Timothy Louis

I thought it would be a good idea to get a Wokesi 1/4" x 3-1/16" end mill to get my 80% down instead of the expensive 4" end mill which is on sale with my template.My plan was to use this shorter and cheaper end mill for most of my routing work and then switch to a 4" end mill to finish the job.. But after only one cut this end mill dulled so visibly that when I was milling the second receiver the milling became noticeably slower and rougher and I ended up spending more time on each pass.While this end mill is 1/3 to 1/4 the price of a quality long end mill, I can get through it faster and therefore minimize, if not eliminate, any savings I thought I could achieve.But hey, if 4 of these cheaper end mills r cost as much as a quality end mill and end up lasting just as long, I'm not going to "put all your eggs in one basket" if a quality end mill breaks or breaks. one of its end blades. I'll let you all know what you're getting.