Review on Installed Detection Detecting Available Filaments by Joshua Romero

Name: Installed Detection Detecting Available Filaments
Item: Installed Detection Detecting Available Filaments
Rating: 3

August 29, 2022

Firmware Issues: Additive Manufacturing Products

So far, this product has lived up to expectations right away. I can't seem to install firmware that works for this filament sensor and BLtouch at the same time. I seem to be allowed to do both now. IDK if other people are having similar issues, but this is a bit annoying. I also printed a sensor mount and where it fits, the cables are barely long enough to reach the motherboard. Otherwise I'd say the thing works great. I know if I can get the correct firmware.

Pros

This 1.75mm diameter filament low sensor unit is designed to detect when your print has run out of filament. If the device detects that the filament has run out during printing, it sends a signal to the main circuit board. With the correct firmware settings, printing will pause until the operator resets the filament and resumes printing.

Cons

So far, so good

New products

Comments (0)

Please, sign in to write a comment

Top products in 🖨️ 3D Printing Supplies

YOYI 3D Printer Filament - PETG 1.75Mm 2.2Lbs(1Kg) Spool, High Accuracy +/- 0.03 Mm, 100% New Raw Material!

4.68

32 Review

WYZworks 1.75Mm Premium PLA Filament - Antique Rosy White/Skeleton | Dimensional Accuracy +/- 0.05Mm | 1Kg/2.2Lb | Multiple Color Options

3.4

30 Review

High-Quality 1.75Mm Light Orange PLA 3D Printer Filament By HATCHBOX - 1 KG Spool With +/- 0.03 Mm Dimensional Accuracy For Exceptional 3D Printing Filament Results

4.69

25 Review