Review on 🔧 Gunsmithing Service: Efficient Removal of Automotive Accessories by Ron Mohammed

As another reviewer mentioned, the stamp is 1/8" too big. I tried a 1/8" Steel bolts to remove an aluminum part. The 1/8" punch was larger than the 1/8" hole that the rolling pin was in. I had to downsize to a 3/32" hole punch. I already used a 1/8" drill bit to clean up the end of the pin as it had grown from installation. I managed to sink the pin and then noticed that the stamp was slightly bent. As I said, it was a steel coil inserted into an aluminum part. The punches are too soft. I could see how this would happen if the reel was in a block of steel but not aluminum.