🔧 Gunsmithing Service: Efficient Removal of Automotive Accessories Review

This product fits approximately 3 pins (3/16 inch). Then I noticed that the stamp started to bend. The product lasted about 20 strokes. The steel is of very poor quality. Not as bad as port transport though.

I have about 8 sets of punches and these should be the longest I have. /8th should only be used as a finisherP.S. I will order another set for 1/16.

Complete junk. The 5 star reviews are clearly not correct. 1/16 leaned towards me from the first hit. I was very gentle with the soft double hammer. Bent. waste of money. Cheap chinese junk isn't worth the free shipping. Buy from a real store. Revain needs to improve the quality control of its litter and all bids should state country or origin.

Required to assemble the PSA assembly. Worked great even used the 2 smallest strokes and they didn't bend on any of the strokes. I also used them to hold and align the parts when placing the pins and then they didn't bend either. I read a few reviews that said they flex slightly, but I feel like you must do it on purpose as these are strong little bumps.

I just received spring pin punches but haven't had a chance to try them yet. However, upon first inspection, the proportions of the structure appear to be wrong throughout the set. Hemispherical tips are too big, making the flat edge around the tips too narrow. I don't think these dies will fit me so I may return them and purchase a better set with the correct design features.

I got them to disassemble the Taurus G2C to replace the trigger. Once I figured out the right diameter, they were easy to use. I managed to bend the smallest one but that was my fault. I've taken this gun apart probably a dozen times to get this custom trigger working, swapped out the safety, and then reinstalled the factory trigger. Shelf.

I haven't actually used any of these in severe conditions but they appear strong and well made. Each item was individually sealed in clear plastic, as was all secondary packaging. Contrary to some other reviews, there wasn't a single sign of rust or obvious imperfections here. I claim the metal was dry and free of oil, which surprised me. This may be an issue for some other reviews. The knurling on the handles was well defined. Overall I would recommend this product.

As another reviewer mentioned, the stamp is 1/8" too big. I tried a 1/8" Steel bolts to remove an aluminum part. The 1/8" punch was larger than the 1/8" hole that the rolling pin was in. I had to downsize to a 3/32" hole punch. I already used a 1/8" drill bit to clean up the end of the pin as it had grown from installation. I managed to sink the pin and then noticed that the stamp was slightly bent. As I said, it was a steel coil inserted into an aluminum part. The punches are too soft. I could