Review on 🔧 Enhance Your Additive Manufacturing Projects with Polymaker ABS Filament 1 by Antoine Scisson

I've always avoided ABS since hearing about styrene releases but after discovering this bulk polymerized ABS I decided to give it a try to try . Slight odor, but only if you press your nose against the printer and push through a large amount of plastic (>10mm^3/s). I had no trouble lifting the first layer or separating subsequent layers like so many stories do. from the ABS body. Run 260/100°C heater/earth in first layer 255/90°C later, very low fan (<10%) seemed to help melt the burrs on the surface of the small parts = Kepton tape with elm/PVA glue diluted and then evaporated glue the touches with purple glue