1 Level
777 Review
37 Karma
Review on πͺ Enhance Precision Cutting: Uxcell Diameter Cutting Reduced Shank for Sharper Results by Jimmy Scaturro
Broke along for the first hole.
If I could put a 0, I would. Drilled a hole in a 3/16" board after clambering through various sizes of other bits and oil cooling. After the first hole, the chisel tip splintered and became sooty. The second hole couldn't be drilled to the end, I had to drill it out with a grinder. Good thing I only needed two holes.
Pros
- Cutting edge diameter: 14 mm / 0.55 inch (9/16 inch); Shank diameter: 12.7 mm / 1/2 in.
Cons
- Not sure
