Review on 🏭 1mm TPU Filament for Improved SEO by Trevor Rodke

I bought this TPU to use with my Ender 3 v2 with Triangle Labs BMG Clone and Phaetus Dragon Fly Hot End in Bowden setup. I used to use TPU with a durability rating of 92a just fine with my setup, but the 92a material was too brittle to print a phone case, so I went with this 95a. Based on my experience with 92a, which is softer and more flexible than 95a, I figured I wouldn't have a problem either, but this 95a kept getting tangled in my extruder so I had to take it apart and untangle it. I didn't have a good impression with it because I kept messing up in the middle of my prints. I had no trouble taking the first layer off and I'm not sure if this TPU requires a direct drive setup, but overall it didn't work for me.