Review on 🔧 Straight Chucking Machine Reamer Milling - Enhanced Precision and Efficiency by Peris Auditore

I bought this set with some skepticism about the quality. Upon arrival, I unpacked the Beats and attempted to remove them from the recording packaging they were in. The plastic case was very flimsy and cheap, which didn't bother me, but a case with separate compartments would have been nice. I had to rip open the suitcase to get them out. But I have a bit of an organizer so again not too much of a problem. After removing the bits, I took my calipers and checked that they were to spec. I was surprised that they were measured to within 0.00mm. The 8mm I tried first was 8.00mm at the time. They were just the right size. I was very impressed that they were so close. I was expecting 0.01 variance but no! My Beats had a very clear writing. I've seen several people leave reviews and say they can't read them, but mine was perfect. The drill bits fit perfectly on my SnapOn 3/8" drill chuck and Jet Mill R8 collets. I had no fit issues and they clamped very well. They seated correctly on the cutter and had no visible deviation, although I didn't check with them a dial indicator. The bits were very sharp and cut well. However, I really wish they were about 3-5" longer, but again, not a deal breaker or enough to remove any star ratings from this review. Overall, I would buy again if you are trying to stay on a budget and need a good reliable tool i would suggest buying these as well.