Review on 📸 KODAK 1 PLA Filament – Enhanced Additive Manufacturing Solutions by Dennis Reed

The first coats of the reel were fine at the time. The layers are hidden under the layers, causing the printer to pull and break the filament. The coil winding is terrible. The chimp could have packed it better. How to wind a coil where layers are underneath other layers? To get any print at all, you should try to pull the foot out and then roll it back while printing so it doesn't mess up your print. Adhesion to the printing platform is also poor. I run almost all of my filament at the same hot end and layer temperature, and this one of my many spools of filament won't stick unless I heat the bed much more than normal. Some areas stick, but the corners stretch and warp too easily. You also pay more for this as it is not a 1kg roll. I would avoid it if I were you. There are many more options with better price and quality.