Review on 🖨️ Enhanced Print Compatibility of PLA Printer Filament by Scot Hughes

I read another review from someone with the same problem. When I felt the container on after more than 5 hours, it was barely warm. I added an internal temperature and humidity reader for testing purposes. Even when fully overclocked to 55C it only got 39.9 and the humidity reading was 44% instead of 15% where it should have been, I even tried a different thermometer and humidity reader. The same thing. It can only be one defective model, but now there are at least two with the same problem. If you have one of these or plan to buy one, check the temperature and humidity readings. It may not work as it should. I'll come back and try another brand. Much luck!