Review on 🖨️ Enhance Your Printing Experience with SUNLU ABS 3D Printer Filament by Nick Cleary

I just received this thread and was happy to find a decent price on ABS. I first tried to print with the recommended settings on the coil side (nozzle 230°C, glass bed 80°C). I used hairspray as the glue for the glass layer as it works very well with PLA filament from other manufacturers. I start to print and the skirt, the first layer, the first 2 hours looks fine. No problems, no deformation. I'll check it out in a few hours and it's a filament nightmare. Spaghetti is everywhere and I have no idea what happened. Looking at the print, it looks like one of the corners came loose during the process. No problem, maybe it's just me because it's my first time riding with ABS. I tried again by increasing the bed and jet temp after reading some reviews here. I spray hairspray and start typing again. The first hours are perfect. and then spaghetti. Since then I've tried 2 more times to print with this filament but each time it's been a nightmare. You can see that other browsers have the same problem while some can print with it without any problem. I used Ender 3 Pro for printing, I hope you have better luck than me.