🚙 Jeep Wrangler JK JL TJ YJ CJ Square Doorless Side Mirrors with Quick Release Door Hinge – Textured Black Review

These mirrors are beautiful and good quality, move freely and look great, match the standard jeep black plastic perfectly, the only downside is the bracket. So I'm giving 4 starts, with its set up and hardware it seems like more of a chore than it takes to put it on but that's just a minor setback, all four stars, I highly recommend this set!

Package received, not delivered immediately. When I opened the box I noticed that one of the mirrors was slightly broken. I had already removed the door from my jeep to go somewhere so I proceeded to install mirrors. While driving I noticed my right hand mirror was starting to move inward so I stopped at a gas station to have the mirror fixed and tightened and kept driving and within 2 miles it was moving inward again. I am not satisfied with the product I have revived and am wondering if I…

Style looks good. I didn't think I would need to read the instructions to install these mirrors. The hardware it came with (as instructed) required me to install a lock washer with a lock nut. Instead of a lock I needed washers. He also had rubber discs that were only enough for 1 installation. If you tie it tight enough that it doesn't move when you move it, but you have to move the mirror or accidentally hit it while walking past, the rubber washers will break. When removing, the mirror…

This is the second set of mirrors I've bought for my Wrangler. The first set like this was rubbish. It never held in place, was difficult to tighten etc. However, this set is infinitely better. It's harder to install as you have to dismantle the entire frame of the mirror every time you turn it on/off, but it also holds up much stronger. I tend to leave my doors/roof open for weeks or months so it's usually not a big deal. Finally, I want a product that will stay in place in 80 mph freeway…

I'm a little concerned at first after seeing some reviews of them not being JL compatible and videos of mirrors blowing in the wind and not staying in place. First, in terms of compatibility, I found it didn't match the angled support arm at first. But if you just decide not to use that, it will and will work just fine. The picture shows how I installed it without the support arm. Second, I had no problem with those mirrors staying in place even at 75 mph. They'll loosen up after a day or two…

Can't keep them where I put them! The wind keeps pushing them back at over 30-35 miles per hour. It's not like I have to drive down the freeway with no doors, but even at 40mph I'm fixing them and a minute later I'm looking in the mirror and I'm looking back at myself and not at the cars behind me. Tightening it would be possible, but I don't want to tear off the paint on the hinges - they already have enough problems with paint. The kit comes with a rubber gasket and I even reinforced the…

I ordered 2 packs; one for each door. They were well packaged and came with a set of spare rubbers. However, they were difficult to install because the holes for the mirror did not line up after the bars were attached to the door hinge. I had to use stainless steel washers. This gave more surface area for the rubber washers so they didn't just cut through the hinge and I could tighten it further. It also complicates the installation of the mirror mount. Mirror rotation wasn't easy to adjust…